DS3232M
±5ppm, I2C Real-Time Clock with SRAM
14
Maxim Integrated
Alarms
The device contains two time-of-day/date alarms.
Alarm 1 can be set by writing to registers 07h–0Ah.
Alarm 2 can be set by writing to registers 0Bh–0Dh.
See Table 2. The alarms can be programmed (by the
alarm enable and INTCN bits in the Control register)
to activate the INT/SQW output on an alarm match
condition. Bit 7 of each of the time-of-day/date alarm
registers are mask bits (Table 2). When all the mask
bits for each alarm are logic 0, an alarm only occurs
when the values in the timekeeping registers match the
corresponding values stored in the time-of-day/date
alarm registers. The alarms can also be programmed
to repeat every second, minute, hour, day, or date.
Table 3 shows the possible settings. Configurations
not listed in the table result in illogical operation. The
DY/DT bits (bit 6 of the alarm day/date registers) con-
trol whether the alarm value stored in bits 0–5 of that
register reflects the day of the week or the date of the
month. If DY/DT is written to logic 0, the alarm is the
result of a match with date of the month. If DY/DT is
written to logic 1, the alarm is the result of a match
with day of the week. When the RTC register values
match alarm register settings, the corresponding alarm
flag A1F or A2F bit is set to logic 1. If the correspond-
ing alarm interrupt enable A1IE or A2IE bit is also set
to logic 1, the alarm condition activates the INT/SQW
signal if the INTCN bit is set to logic 1. The match is
tested on the once-per-second update of the time and
date registers.
Table 3. Alarm Mask Bits
DY/DT
ALARM 1 REGISTER MASK BITS (BIT 7)
ALARM RATE
A1M4
A1M3
A1M2
A1M1
X
1
Alarm once a second
X
1
0
Alarm when seconds match
X
1
0
Alarm when minutes and seconds match
X
1
0
Alarm when hours, minutes, and seconds match
0
Alarm when date, hours, minutes, and seconds match
1
0
Alarm when day, hours, minutes, and seconds match
DY/DT
ALARM 2 REGISTER MASK BITS (BIT 7)
ALARM RATE
A2M4
A2M3
A2M2
X
1
Alarm once per minute (00 seconds of every minute)
X
1
0
Alarm when minutes match
X
1
0
Alarm when hours and minutes match
0
Alarm when date, hours, and minutes match
1
0
Alarm when day, hours, and minutes match
相关PDF资料
DS3232SN#T&R IC RTC W/TCXO 20-SOIC
DS3234S# IC RTC W/TCXO 20-SOIC
DS32C35-33#T&R IC RTC ACCURATE I2C 3.3V 20-SOIC
DS3911T+ IC DAC 10BIT I2C QUAD 14TDFN
DS4000KI/WBGA IC OSC TCXO 19.44MHZ 24-BGA
DS4026S+WCN IC OSC TCXO 25MHZ 16-SOIC
DS4100HW+ IC OSC CLOCK 100MHZ 10LCCC
DS4266P+ IC OSC CLOCK 266MHZ 10-LCCC
相关代理商/技术参数
DS3232MZ+TRL 功能描述:实时时钟 RTC/TCMO/MEMS RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube
DS3232N 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Extremely Accurate I2C RTC with Integrated Crystal and SRAM
DS3232S 制造商:Maxim Integrated Products 功能描述:Extremely Accurate I2C RTC
DS3232S- 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Extremely Accurate I2C RTC with Integrated Crystal and SRAM
DS3232S# 功能描述:实时时钟 Integrated RTC/TCXO/Crystal RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube
DS3232S#T&R 制造商:Maxim Integrated Products 功能描述:EXTREMELY ACCURATE I2C RTC 20SOIC W - Tape and Reel 制造商:Maxim Integrated Products 功能描述:DS3232 3V 20P SOIC 制造商:Maxim Integrated Products 功能描述:IC RTC W/TCXO 20-SOIC
DS3232S#T&R 功能描述:实时时钟 Integrated RTC/TCXO/Crystal RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube
DS3232SN 制造商:Maxim Integrated Products 功能描述:Extremely Accurate I2C RTC